Janty eGo X 900 Black Set

Every 2 to 3 days, the atomizer should be disassembled and cleaned carefully to help prolong its lifespan.

Detach the atomizer cone from the atomizer base and rinse through with lukewarm water. Use a soft cloth with lukewarm water to wipe the outer and inner surfaces of both parts. Dry in shaded area.

Using tweezers or an old toothbrush, carefully remove any residue found on the heating coil. Also, make sure not to disarrange the heating wire lines to avoid short circuiting.

Invert the atomizer cone, exposing the old wick. Using tweezers, clamp the fiber lines together to pull out the wick. Then, pick up the fiber lines of the new wick and securely place the wick into the wick connector hole inside the cone. Finally, attempt to pull out the fiber lines to check if the wick was properly replaced.

Clean your wick regularly with warm water and replace the wick when the wick remains stained black even after washing with warm water.

Clean the tank separately by washing it thoroughly with water and drying it with a piece of cloth afterwards.

Make sure that there is no excess e-liquid inside the screw thread on the batteries; wipe/clean the inside before inserting the battery into the charger.